View source for Single Gas Monitors, Training and Safety

==Section 1 - ADMINISTRATIVE==
===130.11 Single Gas Monitors, Use and Maintenance===

===PURPOSE:===
The Purpose of carrying a single gas detector for the detection of CO on all “First In” bags is to provide early detection of an unknown presence of Carbon Monoxide. These disposable detectors are designed to remain on at all times to warn personnel of a potential hazard and the presence of Carbon Monoxide in the immediate area. 2.

===PROCEDURE:===
* Each apparatus is equipped with a blue back pack or a “First In” bag. Personnel will always carry this equipment bag with a GasAlertClip, CO detector attached to the outside of the bag, into the scene.
* The gas detector measures the presence of Carbon Monoxide. When the detector alarms, crews will exit the area until they are out of harm’s way and don SCBA and PPE prior to reentering the scene.
* The OIC will notify the Battalion Chief and dispatch of the current condition, location, and any other pertinent information.
* The CO detector is designed to operate at all times, monitoring the immediate area. The detector is disposable and generally last 2-3 years.
* A brief calibration test will be performed by crews each morning, during morning checkout. A description of calibration/testing procedures is listed below.

===INSTRUCTIONS:===
* Activate the Detector-If the gas detector is being turned on for the first time then follow the directions below.
*# Move to a normal atmossphere (20.9% O2) that is free from hazardous gas.
*#Press and hold the push button for 5 seconds.
*#The detector beeps and vibrates once.
*#The LEDs flash once.
*#The detector performs a self test. This may take several minutes.
*#When self test is successful, the detector beeps and vibrates once. The detector then displays the Detector Life-Remaining Clock.
*#NOTE: Once the detector is activated, it cannot be deactivated except after a battery life-ending alarm.
* Self-Test- Will be performed each morning at during vehicle checkout. The detector will display a reminder that a self-test is needed every 22 hours.
**Make sure self-test is performed in a hazardous gas free atmosphere.
**Press and hold button for 1 second.
**Confirm that the following tests are performed:
**#The detector beeps and vibrates once.
**#The LEDs flash once.
**#The LCD displays all elements.
**#The LCD flashes TEST while sensor integrity and battery life are tested.
**#The LCD displays low and high alarm set points.
**#If an alarm has occurred in the last 24 hours, the LCD displays the maximum gas exposure value and hours that have elapsed since the exposure. All exposures must be relayed to the OIC and Battalion Chief.
**#The LCD flashes Prn and Wi-Fi symbol.
* Self-Test Fail-If self-test fails, the detector beeps five times and LEDs flash before LCD displays a blank screen. The LCD then returns to the normal operation screen and displays Test. Repeat self-test.
**If self-test fails 3 consecutive times, the LCD displays a blank screen and deactivates.
**Notify your OIC and Battalion Chief if the detector deactivates and they will provide a replacement.
* Detector Life-Remaining Clock
**The detector life-remaining clock counts down the amount of operating time remaining in months, then days, then hours.
**Personnel will notify the OIC when 2 month remaining is displayed on the LCD, so replacements can be made available.
**The detector will alarm when the clock reads 0 hours remaining. The detector continues normal operation for 8 hours.
* Intentional Abuse or Exposure to Gases
**The intentional exposure of gases to the unit is prohibited unless a certified calibration gas is used by an authorized technician.

[[Category:Training and Safety]]